Replacing Door Springs

springNhinge1

The oven and broiler doors on my OKM are spring loaded and they work just fine. I found out, I’m lucky.  Many others report their stoves’ doors don’t close because the springs are broken.  Or, if only one of the two springs works, so the door mightn’t close tightly.  A tightly closed door is important to help keep the heat inside. Since these models don’t have latches or locks the springs are the only components that keep the doors closed. It’s important to replace weak or broken springs.

But how? Where are the silly things? Answer – If you open an oven or broiler door and look closely, you might be able to see the top of a spring just inside the oven wall cavity.

How can they be accessed to be, say, replaced?

Thanks to the parts stoves I acquired, I discovered how. And like most of properties with these stoves, the process is elegantly simple. Even though the springs are hidden in the stove walls, gaining access doesn’t mean tearing apart the stove!

Close the oven/broiler door. If your stove is like mine, when you  open up either of lower doors you’ll see well disguised the spring and hinge access panels on the left and right walls.

springNhingeAccessPanels3

Each panel has two little panel fasteners at the bottom (modern title – canoe or arrow clips).

springNhingeAccessPanels

With a blade screwdriver, the panel can be popped out, exposing the spring and hinge… well maybe the spring, if it hasn’t broken. When the upper door is closed, the spring can be easily accessed and replaced.

doorSpringExposed

Such a nice simple mechanism. When the upper door is open flat, the spring is stretched but is not strong enough to close the door.  But once the door is partially lifted there is  just enough spring power to pull the door close.

doorSpringExposedStretched

 

 

3 thoughts on “Replacing Door Springs”

  1. My broiler door when opened, does not want to stay down. It has to be held down or it pops back up. Is this the way it’s supposed to be? If not, maybe it was replaced with wrong size springs???

    1. Sounds like the wrong springs were put in. They’re too tight, too strong. Finding the right door springs can be a little tricky. They have to be just right; not too weak or strong. You could try either replacing the springs or putting weights in the door to compensate.

Leave a Reply to ddmcc@yahoo.com Cancel reply

Your email address will not be published. Required fields are marked *